Acura Retrofit Procedures
Please
send comments, corrections and additions to:
PParish@delanet.com
Bottom of Page
-
See Acura's Service Bulletin 95-008
-
Special Notes:
-
All retrofit procedures must follow SAE guidelines.
-
Acura has retrofit kits.
-
My recommendations are in line with the aftermarket recommendations. Aftermarket
recommendations are those of companies such as Everco, Four Seasons and
Murray.
-
Recommendations From A/C Shops:
-
Vehicles with POA valves may require adjustment.
-
Vehicles with dual evaporators may not have a large enough condenser for
use with R134a, and may present problems.
You should stay away from retrofitting Nissan vans if possible.
Make sure on all vehicles:
-
The condenser has clean fins and good air flow.
-
There are seals around the condenser to improve the air flow through it.
-
The fan clutch or the coolant fan motor is operating properly.
-
That any air dams etc. are not missing.
-
MINERAL OIL REMOVAL
-
None Recommended
We recommend that you remove as much oil as possible!
-
FLUSHING THE SYSTEM
-
Flushing of the A/C system is not recommended or approved by Acura. We
recommend flushing of parts that are practical, see general retrofit procedures.
-
O-RINGS & GASKETS
-
All o-rings and gaskets replaced should be R134a compatible. We recommend
that you cover all o-rings and fittings with mineral oil.
-
HOSE REPLACEMENT
-
Acura does not recommend the replacement of hoses unless they show signs
of leaking.
-
COMPRESSOR
-
Acura states that the compressor is not part of the normal retrofit. When
you do change a compressor make sure you know what type oil it contains.
-
CONDENSER AND AIR FLOW (HEAT EXCHANGE)
-
Acura does not make recommendations of condenser replacement. We see potential
problems and needs in this area, see general retrofit procedures. When
you do replace the condenser, try to use a improve multiflow model.
-
FILTER DRIER / ACCUMULATOR REPLACEMENT
-
Acura does not make recommendations of drier/accumulator. replacement.
Acura recommends the replacement of the drier with one that contains XH-7
or XH-9 desiccant.
-
EXPANSION VALVE
-
The expansion valve is not part of the normal retrofit. Some shops I have
talked to install new expansion valves when they retrofit a dual evaporator
systems.
-
EVAPORATOR
-
The evaporator is not part of the normal retrofit.
-
HIGH PRESSURE RELIEF VALVE (HPRV)
-
No recommendations.
-
HIGH PRESSURE CUTOUT (HPCO) SWITCH
-
No recommendations. We think a high pressure cut out switch is a worth
while safeguard.
-
OTHER PARTS
-
No recommendations.
-
OIL REPLACEMENT
-
Refill the system with a full charge of the proper PAG oil. We recommend
that you use Ester oil if you flush.
-
SERVICE PORT ADAPTERS
-
Special R134a only service ports that meet SAE requirements are required
by law.
-
REFRIGERANT REPLACEMENT FOR R12
-
Recharge the system with about 15% less R134a than the R12 specification.
-
LABELS
-
Special R134a service labels that meet SAE requirements are required by
law.
| Return to E38.org | Retrofit
Index Page |
Top Of Page